Built-in and over-the-range microwave repair
A countertop microwave is usually cheaper to replace — but a built-in, drawer or over-the-range unit is part of a matched, fitted kitchen suite, and replacing one often means replacing the look of the whole run. That is where repair makes sense, and where it should only be done by a trained technician. Microwaves store a lethal charge in the high-voltage capacitor even when unplugged, so the no-heat repairs that look simple are genuinely dangerous for a DIYer. We discharge, test and repair them safely.
The repairs we perform
The most common fault is a microwave that runs, lights and turns but does not actually heat — typically a failed magnetron, high-voltage diode or capacitor. Sparking or arcing inside usually means a burned waveguide cover or damaged cavity paint, which we repair before it worsens. We also fix turntable motors, door-interlock switches (a critical safety system), touch panels and control boards. On over-the-range units we service the vent fan and cooktop light as well. We use genuine OEM parts and verify safe operation before we leave.
- Over-the-range, built-in, drawer and trim-kit microwaves
- Magnetron, diode, capacitor and high-voltage component replacement
- Door-interlock, turntable, panel and vent-fan repair
- 6-month parts-and-labor warranty on every microwave repair
When repair is the right call
We will always tell you honestly when a microwave is not worth repairing. For built-in and suite-matched units, though, a magnetron or board repair is typically a fraction of the cost and disruption of replacing a fitted appliance — and we make that call with you, not for you.
Common problems we fix
- Runs but does not heat
- Sparking or arcing inside
- Turntable will not turn
- Door / latch faults
- No display or dead panel
- Loud humming or buzzing
Frequently asked questions
My microwave runs but does not heat food. Can it be fixed?
Yes — no-heat is usually a failed magnetron, high-voltage diode or capacitor. These are dangerous to test without training because the capacitor holds a charge, so it is genuinely a job for a technician. For built-in units the repair is well worth it.
Is it worth repairing an over-the-range microwave?
Usually yes. Because it is fitted to your cabinetry and matched to your range, replacement is costly and disruptive. A targeted component repair is typically far more economical.
Sparking inside the microwave — is it safe to use?
Stop using it. Arcing is usually a burned waveguide cover or damaged cavity surface and will get worse. We can repair it quickly and safely.